D Worn control arm bushings or tie rod D Replace the control arm bushings or ends. Install the turn signal switch and wiper switch. D Loosen the condenser pipe--to--compressor pipe fitting 1. D Disconnect the idle air control valve connector 3. Important: Mark the place and direction of shift fork and yoke to install easily before removing them. Install the counter shaft fourth gear. D Remove the leading shoe 6.
Go to Step 9 Go to Step 10 Replace the contaminated fuel. Notice: Complete the testing in a minimum amount of time to prevent overheating and damaging the solenoid. D Remove the bolts 1. D Remove the fuel filter 3. D Records any faults which are discovered.
D Abnormal interference of D Replace the piston ring. Remove the ventilation duct retaining screws. Refer to Section 4C, Power Booster. If leaks are found, correct the cause of the leak and bleed the system. D Disconnect the cables from the cable bracket. Install the brake pads and the cylinder assembly with the pin bolt. Repair or replace the generator if the generator output is less than the value specified.
Perform the diagnostic system check. Outer Large Boot Clamp 7. Whining Noise in the Steering Pump D Scores of the pump shaft bearing D Replace the power steering pump. D Physical damage to the wiring harness. Install the wheel cylinder assembly. Inspect for faulty connections and repair as — needed.
Listen for in-tank fuel pump operation. Refer to Section 4C, Power Booster. D Push strongly the steering column shaft downward 6. Remove the tie rod end lock nut. Repair the wire of the connector terminals as needed. D Disconnect the blower resistor connector 1. Refer to Section 9O, D18B506B Bumpers and Fascias.
D Remove the retaining spring 4. D Refill recommended fluid to the proper level. D Remove the bolt 1. Is the temperature door travel correct? Normal scan tool voltage varies between 0. D105B703 D Remove the rack and pinion boot clamp 3. D Remove the locking of the alignment spacer 5.
Clean the inside and the outside of the surge tank and the surge tank cap with soap and water. And install the surge tank. Repair or replace any ignition system components as needed. Raise and suitably support the vehicle. D Remove the trailing arm—to—rear axle bolts 1. A passing system always reports to the diagnostic executive immediately. Disconnect the high side hose from the vehicle.
Does the scan tool indicate that this diagnostic ran and passed? Reconnect the negative battery cable. The proportion- ing is operation. Are all checks and repairs complete? D Remove the nuts 1. D Remove the bolts 1. A portion of the fluid also primes the pump. D Straighten the cotter pin and remove it 1. Repair or replace them, as needed.
D Remove the speedometer drive gear 1. D Disconnect the cable 2. Notice: Remove the rack gear toward the driver side of the steering gear to prevent the bulk head in the steering gear housing from damaging in installing and removing the rack gear. The cate the position of the 1 piston during its power stroke. Does the scan tool indicate that this diagnostic ran and passed? D Install the left side case cap with the bolts includ- ing O—ring 1. Also, an extended crank time would be no- ticed on some engines.